14 Matching results
How to fit a guard to a RYOBI Angle Grinder
It is important that the grinder is always used with a guard fitted, and (if included in your model) the additional clip-on guard if you are cutting. To fit the guard, place the guard on the grinder housing with the grooves aligned (arrow…
Last update: 11/08/2023, 15:29
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
RYOBI Heat Gun won't heat up
If your RYOBI Heat Gun won't heat up, after turning it on, make sure you've allowed enough time for the gun to prepare itself - as the unit takes 1-2 minutes to heat up. If your Heat Gun is still not reaching the proper temperature, you may need to…
Last update: 12/08/2022, 11:03
RYOBI Heat Gun won't turn on
If your RYOBI Heat Gun won't turn on, check the power outlet is working, ensure the plug is firmly plugged into the power outlet and untangle any knot on the power cord. You should also check your extension lead - make sure that extension leads with…
Last update: 11/08/2022, 10:41
RYOBI Heat Gun is cutting out
If your RYOBI Heat Gun is cutting out, check if the plug of the unit is firmly plugged in, untangle any knot on the cord, and ensure the nozzle of the unit isn't too close to the heating surface and causing it to overheat. You should also check if…
Last update: 10/08/2022, 13:02
RYOBI Brad Nailer not firing or is misfiring
Remove battery for inspecting the tool. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are being used. Check for any jams. In the event of a jam, open…
Last update: 06/02/2023, 18:27
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26