8 Matching results
RYOBI Heat Gun won't heat up
If your RYOBI Heat Gun won't heat up, after turning it on, make sure you've allowed enough time for the gun to prepare itself - as the unit takes 1-2 minutes to heat up. If your Heat Gun is still not reaching the proper temperature, you may need to…
Last update: 12/08/2022, 11:03
RYOBI Heat Gun won't turn on
If your RYOBI Heat Gun won't turn on, check the power outlet is working, ensure the plug is firmly plugged into the power outlet and untangle any knot on the power cord. You should also check your extension lead - make sure that extension leads with…
Last update: 11/08/2022, 10:41
RYOBI Heat Gun is cutting out
If your RYOBI Heat Gun is cutting out, check if the plug of the unit is firmly plugged in, untangle any knot on the cord, and ensure the nozzle of the unit isn't too close to the heating surface and causing it to overheat. You should also check if…
Last update: 10/08/2022, 13:02
RYOBI Brad Nailer not firing or is misfiring
Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are…
Last update: 05/09/2024, 13:07
RYOBI Brad Nailer not firing or is misfiring
Remove battery for inspecting the tool. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are being used. Check for any jams. In the event of a jam, open…
Last update: 06/02/2023, 18:27
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 05/09/2024, 13:40
RYOBI Brad Nailer jamming
Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Always ensure the correct gauge of nails is being used. We also recommend you confirm the angle required for collation nails matches that of the Nail…
Last update: 17/09/2024, 18:52