RYOBI Brad Nailer Brads aren’t flush

Adjusting Fastener Driving Depth

To ensure your fasteners are driven to the correct depth, follow these steps. Always test on a scrap workpiece before starting your actual project.

Safety First

• Always disconnect the air supply before making any adjustments.

1. Adjust Air Pressure (Pneumatic Models)

• Locate the air pressure adjustment dial on the back of the nailer.
• Rotate the dial to increase or decrease pressure.
• Drive a test fastener and assess the depth.
• Repeat adjustments as needed until the desired depth is achieved.

2. Use the Depth Adjustment Knob

• Disconnect the tool from the air supply before making any adjustments.
• Turn the depth adjustment knob left or right to increase or decrease driving depth.
• Reconnect the air supply.
• Drive a test fastener after each adjustment until the desired depth is reached.