12 Matching results
RYOBI Drill has no power or is losing power
Check if the battery is charged - if so, try another battery to confirm whether it is the tool or battery that isn’t working. Inspect your Drill for dust build up - if there, we recommend removing debris from your Drill with a clean paint brush,…
Last update: 19/08/2022, 15:49
RYOBI Heat Gun won't heat up
If your RYOBI Heat Gun won't heat up, after turning it on, make sure you've allowed enough time for the gun to prepare itself - as the unit takes 1-2 minutes to heat up. If your Heat Gun is still not reaching the proper temperature, you may need to…
Last update: 12/08/2022, 11:03
RYOBI Heat Gun won't turn on
If your RYOBI Heat Gun won't turn on, check the power outlet is working, ensure the plug is firmly plugged into the power outlet and untangle any knot on the power cord. You should also check your extension lead - make sure that extension leads with…
Last update: 11/08/2022, 10:41
RYOBI Heat Gun is cutting out
If your RYOBI Heat Gun is cutting out, check if the plug of the unit is firmly plugged in, untangle any knot on the cord, and ensure the nozzle of the unit isn't too close to the heating surface and causing it to overheat. You should also check if…
Last update: 10/08/2022, 13:02
RYOBI Multi Tool sparking when turned on
Sparking can occur on new, brushed motor tools due to the brushes within the motor not being worn in. This is not an issue and over time, this will stop occurring - it's caused by friction against the carbon brushes. However, if there are…
Last update: 19/04/2023, 16:27
Can I use RYOBI Multi Tool to remove silicone?
A RYOBI Multi Tool can be used to remove silicone sealant with a compatible blade. We recommend the POWERFIT 52mm 2PC Scraper Blade, which you can purchase separately.
Last update: 19/04/2023, 16:30
How to install or change RYOBI Multi Tool blade
To change blades, release the latch by pulling it upwards until the blade holder opens. Ensure the lever is fully released before removing or inserting a new blade. Once the new blade is inserted, pull down the lever until the blade holder snaps…
Last update: 18/09/2023, 09:59