18V ONE+ Airstrike 15Ga Da Finish Nailer - Tool Only (R18NL15-0)

If your RYOBI Nailer or Stapler has a jammed nail or staple, try disconnect the Battery from the tool. Then, remove the nails or staples that aren’t jammed from the tool magazine, which takes the pressure off the jammed nail/staple. Pull up on the…

Before you begin, make sure that you use 15ga DA Brad Nails, as any other gauge will damage the Nailer. We recommend the PowerFit DA Angle Brad Nails Project Pack. To load the nails, disconnect the battery from the Nailer before loading nails into…

Regular basic maintenance will help provide trouble free operation. Collated nails and staples usually have glue on them to bind them together, which over time, can leave a residue on the magazine and the firing pin. To remove residue, disconnect…

If you find your nails don't fire deep enough or your brads aren't flush, try the following: Check the battery to ensure there’s enough charge (at least 2 bars on the battery fuel gauge). Check the power adjustment dial or switch that is…

Ryobi Nailers and Staplers are commonly fitted with a line-lockout which prevents the tool from jamming when the nails are low (approximately when there's 5 nails left). If this occurs, replenish the magazine with more nails or staples.

The recommended battery for all Fastener tools is the RYOBI 18V ONE+ Compact 4.0AH Battery (RB1840C) it has a good balance of power, runtime, and weight. However, any battery from the RYOBI ONE+ range is suitable. Just note that higher capacity…

RYOBI Nailers and Staplers are designed for specific fasteners compatible to these RYOBI tools. Using incorrect-sized fasteners can be dangerous and will result in the tool jamming or breaking - voiding the warranty. Ensure the nails you used are…