How to Load Nails in a Ryobi Nail Gun: Step-by-Step Guide

Before You Begin:

• Always use 15-gauge DA Brad Nails. Using any other gauge may damage the Nailer.

Safety First 

• Remove the battery from the tool before doing any adjustments to the tool 

To Load Nails into the Magazine: 

1. Pull back the tension latch

○ located on the side of the magazine, pull until it clicks and locks into place at the rear or bottom of the magazine.
 

2. Insert the nails  

○ into the rear of the magazine, past the tension latch, and slide them forward as far toward the nose of the tool as possible. 

3. Press the release button 

○ The tension latch will spring forward and secure the nails in place. 

○ Note: If you skip this step, the nails will not be held properly in the magazine.