SEARCH results
410 Matching results
How to setup starting height for RYOBI Thickness Planer
To get a starting height of your RYOBI Thickness Planer for the cutting drum, wind the handle up and slide the timber in. Next wind the handle back until the cutter just rests on the timber. Noting the position of the handle, wind it back up two…
Last update: 29/08/2023, 09:56
How much material can you take off with a RYOBI Thicknesser?
Though 3mm is the recommended maximum amount, this will depend on the hardness of the wood. The harder it is, the less per pass you should take off. Keeping to around 0.5-1mm per pass may take longer, but this process not only prevents motor…
Last update: 02/09/2022, 16:54
Why does my RYOBI Thicknesser stop during use?
If during use your RYOBI Thicknesser just stops, it’s probably because you’re attempting to remove too much material in a single pass, which can overload the motor. Simply hit the stop button, wind up the handle and then press the overload button to…
Last update: 02/09/2022, 16:55
Why are the feed rollers slipping in my RYOBI Thicknesser?
There are several possible causes for this resulting in the rollers requiring replacement from a service agent. It could be caused by general wear if the machine is older or the rollers are damaged from allowing them to do all the work without ample…
Last update: 02/09/2022, 16:57
What to do if your RYOBI Thicknesser blades wear unevenly
If your RYOBI Thickness Planer blades wear unevenly, this can occur from consistently feeding narrow width timbers in at the same position. When planing narrow width timber, try to mix up where you feed it into the machine as this process results in…
Last update: 02/09/2022, 16:58
Why is the auto feed not working in my RYOBI Thicknesser?
If your auto feed isn't working in your RYOBI Thickness Planer, it could be caused by general wear if the machine is older or the rollers are damaged from allowing them to do all the work without ample support of feeding the timber through the…
Last update: 02/09/2022, 16:58
Why is my RYOBI Thicknesser taking off un-even material across the timber?
If your RYOBI Thicknesser takes off an un-even amount of material across the timber, it's usually from consistently feeding narrow width timbers in at the same position. When planing narrow width timber, try to mix up where you feed it into the…
Last update: 20/09/2022, 16:07
Additional Support
MY RYOBI
PRODUCT MANUALS
WARRANTY
WHERE TO BUY
SAFETY NOTICES
