9 Matching results
Product Safety Recall Airwave 2-in-1 C1 Brad Nailer/Stapler RA-NBS1832-S
The product that is the subject of the recall is the RYOBI RA-NBS1832-S Airwave 2-in-1 C1 Brad Nailer/Stapler. The Product has been sold through Bunnings retailers throughout Australia from 1 October 2021 – 31 March 2024. Affected products will…
Last update: 20/05/2024, 16:11
Why does my RYOBI Air Compressor make a hissing sound?
That noise is normal and occurs each time the pump automatically turns off once the tank is full or is switched off via the compressor’s on/off switch. The release of air is the pump unloading the built-up air in the system ready for the next time…
Last update: 31/07/2023, 14:20
How to turn RYOBI Air Compressor on and off
Compressors should only be turned on and off from their power button. Switching an Air Compressor off from the power outlet won’t allow for unloading to occur, which will then lead to stalling the Compressor’s electric motor the next time you try to…
Last update: 10/07/2023, 15:10
How to reset RYOBI Air Compressor
Refer to the reset label to find the button to reset your RYOBI Air Compressor.
Last update: 04/10/2022, 17:41
What is the reset button on a RYOBI Air Compressor used for?
The ‘Reset Button’ resets the motor after the circuit breaker has ‘tripped it’, which protects the electric motor from burn out or any time it’s under extreme load. Once tripped, the motor will not run.
Last update: 31/10/2022, 16:27
RYOBI Brad Nailer not firing or is misfiring
Remove battery for inspecting the tool. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are being used. Check for any jams. In the event of a jam, open…
Last update: 06/02/2023, 18:27
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 16/03/2023, 11:20