7 Matching results
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
How to clean a RYOBI Lawn Mower
For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…
Last update: 25/11/2022, 14:58
When to change RYOBI Lawn Mower blades
The need to replace your blade will depend on a variety of factors. As a guide, it is advised to visually inspect the condition of your lawn mower blades in between mowing sessions. If you notice chips in the blade, rust or a blunt cutting edge,…
Last update: 25/11/2022, 14:59
Why is my RYOBI Drill Driver slow to drill into brick?
To drill into brick, make sure you’re using a RYOBI Drill with a hammer function. Select this mode and use a Masonry Drill Bit. You can improve the drilling speed by selecting a high gear (commonly gear 2 – where possible) - this is usually located…
Last update: 31/01/2023, 13:20
How to lock & unlock a RYOBI 18V ONE+ 184mm Mitre Saw's handle
To unlock the handle of a 18V ONE+ 184mm Mitre Saw, pull down the handle and hold it there. The saw handle is locked down with a pin located on the right. Then pull the locking pin all the way out. Slowly bring up the saw handle and then check it…
Last update: 13/09/2023, 10:46
Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle
If your RYOBI 18V ONE+ 184mm Mitre Saw has a jammed handle, it's possible the saw handle was pulled up or down with it's locking pin not fully in our out and is now obstructing movement. Check that the locking pin is correctly positioned either…
Last update: 13/09/2023, 10:42
RYOBI 18V ONE+ 184mm Mitre Saw's handle won't move
If your RYOBI 18V ONE+ 184mm Mitre Saw handle won't move up or down freely, don't force it as it can damage the tool. It's likely the locking pin isn't fully in or out, and is obstructing movement. Check that the locking pin is correctly positioned…
Last update: 13/09/2023, 10:44