Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle

How to Fix a Jammed Handle on a RYOBI 18V ONE+ 185mm Mitre Saw 

Safety First 

• Remove the battery before attempting any adjustments.
• Wear gloves to protect your hands. 

Step-by-Step Instructions 

1. Pull down the handle and hold it in the lowered position 
This relieves pressure on the locking pin. 

2. Locate the locking pin on the right-hand side of the saw 

• If the pin is stuck, gently wiggle it while pulling outward.
• Do not force it with excessive pressure—this can damage the mechanism. 

3. Apply light lubrication if needed 

• Use a small amount of silicone spray or dry lubricant around the pin area to free any debris or dust.
• Wipe away excess lubricant to avoid attracting more dust. 

4. Check for obstructions 

• Inspect the area around the pin and handle for sawdust or debris.
• Clean thoroughly using a brush or vacuum. 

5. Release the pin fully and slowly raise the handle 

• Once the pin moves freely, pull it all the way out and gently lift the handle.
• Check that the handle moves up and down without resistance. 

6. Test the lock/unlock function 

• Push the pin back in to lock the handle, then pull it out to unlock.
• If the mechanism still jams, contact an authorised service centre.