10 Matching results
How to avoid poor/no suction with a RYOBI Wet & Dry Vacuum
If your RYOBI Wet & Dry Vacuum has poor or no suction, it may be because the filter is dirty and needs to be cleaned. It could also be because the filter is too old to be cleaned, and needs to be replaced. We also recommend you check and empty the…
Last update: 03/02/2023, 11:44
How to swap out your RYOBI Wet & Dry Vacuum filter
To swap out the filter that's used for dry pickup for the one used for wet, simply take it off and grab the foam filter designed for wet pickup and slide it over. Make sure you place it on nice and firm so it protects all the insides. If you use the…
Last update: 19/09/2022, 16:43
How to clean your RYOBI Wet & Dry Vacuum & filter
We recommend straight after you use your machine for wet vacuuming, to clean it and have it setup ready for next time - particularly if the next time is to use the dry feature. The first step is to drain all the water out and then wipe and clean the…
Last update: 26/09/2022, 11:41
RYOBI battery-powered Nailer or Stapler doesn’t fire deep enough
If you find your nails don't fire deep enough or your brads aren't flush, try the following: Check the battery to ensure there’s enough charge (at least 2 bars on the battery fuel gauge). Check the power adjustment dial or switch that is on the back…
Last update: 17/09/2024, 18:50
What nails, staple types or sizes can I use in a RYOBI Nailer or Stapler?
RYOBI Nailers and Staplers are designed for specific fasteners compatible to these RYOBI tools. Using incorrect-sized fasteners can be dangerous and will result in the tool jamming or breaking - voiding the warranty. Ensure the nails you used are…
Last update: 05/09/2024, 18:31
What battery is best to use with a RYOBI Nailer or Stapler?
The recommended battery for all Fastener tools is the RYOBI 18V ONE+ Compact 4.0AH Battery (RB1840C) it has a good balance of power, runtime, and weight. However, any battery from the RYOBI ONE+ range is suitable. Just note that higher capacity…
Last update: 10/09/2024, 19:10
How to load nails into a RYOBI 18V 18ga Brad Nailer
Before you begin, make sure that you have 18ga C1 Brad Nails, as any other gauge will damage the Nailer. We recommend the PowerFit C1 Series Galvanised Brad Nails Project Pack - 4000 Pack. First, before loading nails into the magazine, remove the…
Last update: 05/09/2024, 17:08