7 Matching results
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 16/03/2023, 11:20
RYOBI Brad Nailer jamming
It's likely a jammed fastener - disconnect the air hose to remove the jammed fastener. Additionally, always ensure the correct gauge of nails is being used, and check the nails are straight and in condition.
Last update: 08/08/2022, 16:38
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26
Tools required to install RYOBI LINK to a plasterboard wall
Make sure you have the following tools to install the RYOBI LINK Wall.
Last update: 27/09/2023, 14:25
How to install RYOBI LINK rail to a plasterboard wall
Step-by-step instructions and a how-to video guide on how to install RYOBI LINK Rail/s on a plasterboard or brick wall.
Last update: 27/09/2023, 14:51
How much weight can RYOBI Link hold?
The LINK Rail supports 94kg overall for each rail or 34kg per 280mm. Overall holding weight varies depending on how the rail is fixed to the wall.
Last update: 27/09/2023, 14:53
Can’t tighten screw into anchor when installing RYOBI LINK
This can occur if a Drill Bit larger than 9mm was used & the hole is too big. The maximum Drill Bit & hole size for the RYOBI LINK Wall Anchors is 9mm.
Last update: 27/09/2023, 14:53