6 Matching results
RYOBI Brad Nailer not firing or is misfiring
Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are…
Last update: 05/09/2024, 13:07
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 05/09/2024, 13:40
RYOBI Brad Nailer jamming
Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Always ensure the correct gauge of nails is being used. We also recommend you confirm the angle required for collation nails matches that of the Nail…
Last update: 17/09/2024, 18:52
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment knob to reach the preferred fastening effect. The amount of air pressure…
Last update: 05/09/2024, 16:43
What to do if your RYOBI Shredder has stopped working
If your RYOBI Shredder stopped working, the chute may be blocked by debris – unplug the unit and clear the blockage. Also, check if the circuit breaker is overloaded.
Last update: 29/08/2022, 11:44
What to do if your RYOBI Shredder is low on power
Your RYOBI Shredder may be low on power if you’re using too many extension leads or a lead that is too long. It’s recommended to use a heavy-duty extension lead no longer than 25m.
Last update: 30/08/2022, 08:27