How can we help?

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

RYOBI Angle Grinder disc has overtightened and jammed

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc.  To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc: 

Last update: 13/09/2024, 13:20

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Nailers & Staplers
• Brad Nailers
• Troubleshooting

RYOBI battery-powered Nailer or Stapler doesn’t fire deep enough

If you find your nails don't fire deep enough or your brads aren't flush, try the following: Check the battery to ensure there’s enough charge (at least 2 bars on the battery fuel gauge). Check the power adjustment dial or switch that is on the back…

Last update: 17/09/2024, 18:50

• Nailers & Staplers
• Brad Nailers
• Getting Started

What nails, staple types or sizes can I use in a RYOBI Nailer or Stapler?

RYOBI Nailers and Staplers are designed for specific fasteners compatible to these RYOBI tools. Using incorrect-sized fasteners can be dangerous and will result in the tool jamming or breaking - voiding the warranty. Ensure the nails you used are…

Last update: 05/09/2024, 18:31

• Nailers & Staplers
• Brad Nailers
• Getting Started

What battery is best to use with a RYOBI Nailer or Stapler?

The recommended battery for all Fastener tools is the RYOBI 18V ONE+ Compact 4.0AH Battery (RB1840C) it has a good balance of power, runtime, and weight. However, any battery from the RYOBI ONE+ range is suitable. Just note that higher capacity…

Last update: 10/09/2024, 19:10