How can we help?

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

RYOBI Angle Grinder disc has overtightened and jammed

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc.  To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc: 

Last update: 13/09/2024, 13:20

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Nailers & Staplers
• Brad Nailers
• Troubleshooting

RYOBI Brad Nailer not firing or is misfiring

Disconnect the tool from the air supply before any checks and keep the tool pointed away from you. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are…

Last update: 05/09/2024, 13:07

• Nailers & Staplers
• Brad Nailers
• Troubleshooting

RYOBI Brad Nailer not firing or is misfiring

Remove battery for inspecting the tool. Check if there are fasteners in the magazine by dislodging the magazine latch and inspecting it. Ensure the correct gauge nails for the Nailer are being used. Check for any jams. In the event of a jam, open…

Last update: 06/02/2023, 18:27

• Nailers & Staplers
• Brad Nailers
• Troubleshooting

RYOBI Brad Nailer Brads aren’t flush

The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…

Last update: 05/09/2024, 13:40