How can we help?

• Grinders
• Angle Grinders
• Application

Can I use a larger disc size with my RYOBI Angle Grinder?

Don’t use a disc larger than the maximum cutting capacity outlined below and in the product user manual, as a larger disc can cause damage to the tool, and potentially harm you or a bystander.

Last update: 13/09/2024, 11:06

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Cannot tighten Drill Driver Bit in RYOBI Drill Driver chuck

Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.

Last update: 11/09/2024, 16:11

• Drills & Drivers
• Drill Drivers
• Getting Started

What are the settings for on my Ryobi Drill Driver?

The settings are to help with drilling holes & driving screws properly into the desired material.

Last update: 11/09/2024, 17:42

• Drills & Drivers
• Drills
• Troubleshooting

RYOBI Drill has no power or is losing power

Check the battery charge level – it is normal that a battery will lose some minor power output as the charge level drops. If the charge level is too low, the tool may stop under load. In this case you may need to charge your battery or change…

Last update: 11/09/2024, 12:17