![TTI Brands Home](/themes/custom/tti/images//icons/logo.png)
22 Matching results
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
How to fit a guard to a RYOBI Angle Grinder
It is important that the grinder is always used with a guard fitted, and (if included in your model) the additional clip-on guard if you are cutting. To fit the guard, place the guard on the grinder housing with the grooves aligned (arrow…
Last update: 11/08/2023, 15:29
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
RYOBI Drill has no power or is losing power
Check if the battery is charged - if so, try another battery to confirm whether it is the tool or battery that isn’t working. Inspect your Drill for dust build up - if there, we recommend removing debris from your Drill with a clean paint brush,…
Last update: 19/08/2022, 15:49
Drill Bits slip in RYOBI Drill Driver chuck
Depending on the type of chuck, it’s common for smaller Drill Bits (around 1-3mm or less) not to grip. The Drill Bit may also have dust or liquid on the Bit, which might cause it to slip - this can be prevented by cleaning the end of the Drill Bit…
Last update: 24/08/2023, 14:24
RYOBI Drill Driver chuck hard to adjust
If your RYOBI Drill Driver chuck is hard to adjust, the chuck might have debris in the jaws, which could make adjusting the chuck stiff. Open the chuck fully and clean out any build-up of dirt and dust - preferably with compressed air.
Last update: 09/08/2022, 14:39
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09