36V HP™ Brushless 46cm Lawn Mower 6.0ah Kit (R36XLMW16)

To adjust the cutting height, slide the adjusting lever forward to unlock. Then raise the cutting height or push the mower down to lower the cutting height. Release the lever to lock it in place.

To adjust a 36V RYOBI Lawn Mower's handle height, unclip the two height adjustment clamps and pull the handle out to the desired position and lock it off. You can also adjust the angle of the handle by pulling the quick release fastener out and…

The mower itself comes pre-assembled, all that's required is to unfold the handles and assemble the grass catcher. Before you assemble your mower, you should put your battery on charge so it's ready to go upon assembly. 

For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…

The motor is controlled by the thumb paddle, which when pushed drives the mower forward. Speed is then controlled by the slider switch, which allows you to set your desired pace. We recommend starting off slow until you get used to it.

To reset a 36V RYOBI Lawn Mower's blade check warning light, hold down the battery icon on the dashboard for 3 seconds.

The Blade Check warning LED is a handy reminder to check the condition of the blade. This reminder will pop up every 10 hours of use. Holding down the battery icon on the dashboard for 3 seconds will reset it and the 10 hour timer will begin again.…

A dashboard is located at the top of the Mower's handle. It provides a single point to set the three moving modes, and pressing the mode button cycles through each of the modes. ECO mode locks the blade in low speed to provide the best runtime…

To improve the power of your mower, ensure your battery is fully charged, raise your cutting height setting, walk slower, and wait until your lawn fully dries before mowing. An HP battery such as a 6.0Ah or 9.0Ah will improve your mowers…

Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher.
Mowing in wet or unruly conditions are often the…

The need to replace your blade will depend on a variety of factors. As a guide, it is advised to visually inspect the condition of your lawn mower blades in between mowing sessions. If you notice chips in the blade, rust or a blunt cutting edge,…