18V ONE+ 2.0/5.0Ah Brushless Drill Driver Kit (R18DDBL-55S)

Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.

The Drill Bit may have dust or liquid on the Bit, which might cause it to slip - this can be prevented by cleaning the end of the Drill Bit that goes into the chuck.

Check that the Drill may is set on the correct drill or driving settings, the speed may be too high/ low, in reverse instead of forward, or the Adjustable clutch may not be set to the Drill mode (when drilling.) Generally, Slower the speed, the more…

The chuck might have debris in the jaws, which could make adjusting the chuck harder or stiff. Open the chuck fully and clean out any build-up of dirt and dust - preferably with compressed air.

Check the battery charge level – it is normal that a battery will lose some minor power output as the charge level drops. If the charge level is too low, the tool may stop under load. In this case you may need to charge your battery or change…

Check the battery charge level – it is normal that a battery will lose some minor power output as the charge level drops. If the charge level is too low, the tool may stop under load. In this case you may need to charge your battery or change…