8 Matching results
RYOBI Pressure Washer has low or no water pressure
Discover step-by-step solutions for fixing low or no water pressure issues in your RYOBI Pressure Washer.
Last update: 20/10/2023, 08:50
How to set up a RYOBI Pressure Washer
Before you start using your Pressure Washer, you have to prime the line. Ensure the machine is in the off position. Turn on the water supply. Squeeze the trigger until you see a night steady stream of water. Once achieved, the system is primed and…
Last update: 29/08/2023, 12:34
How to set RYOBI Pressure Washer to dispense soap
Depending on the Pressure Washer you own, the soap dispenser will be located in the front or back. If your Pressure Washer has a feed tube, it's important that when you put the cap back on, that the tube is pushed all the way to the bottom of the…
Last update: 29/08/2023, 12:37
What does a RYOBI Thicknesser do?
A Thicknesser, also known as a Planer-Thicknesser is essentially a benchtop version of a hand planer. It’s used to plane wood to a consistent thickness throughout its length. They can also be used to square off posts while at the same time removing…
Last update: 02/09/2022, 16:48
How to feed timber using a RYOBI Thickness Planer
To feed timber into a RYOBI Thickness Planer (also known as a Thicknesser), at the front of the machine, there's a sealed power switch with emergency stop button. To turn it on, unclip and lift the cover, press the green button, and rest the cover…
Last update: 29/08/2023, 09:47
How to setup starting height for RYOBI Thickness Planer
To get a starting height of your RYOBI Thickness Planer for the cutting drum, wind the handle up and slide the timber in. Next wind the handle back until the cutter just rests on the timber. Noting the position of the handle, wind it back up two…
Last update: 29/08/2023, 09:56
How much material can you take off with a RYOBI Thicknesser?
Though 3mm is the recommended maximum amount, this will depend on the hardness of the wood. The harder it is, the less per pass you should take off. Keeping to around 0.5-1mm per pass may take longer, but this process not only prevents motor…
Last update: 02/09/2022, 16:54