How can we help?

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

RYOBI Blower Vacuum won’t start

If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…

Last update: 16/08/2023, 11:52

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

Why has my RYOBI battery-powered Blower Vacuum lost suction?

If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…

Last update: 01/02/2023, 15:59

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

RYOBI Blower Vacuum can’t switch between modes

If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.

Last update: 26/08/2022, 14:33

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

What to do if your RYOBI 18V HP Garden Vacuum & Sweeper won't start

If your RYOBI 18V HP Garden Vacuum & Sweeper won't start, check the battery has charge by pressing the fuel gauge button at the front of it - it needs to have two or more LEDs on. At the top of the handle there is a red LED. If this blinks, it means…

Last update: 13/10/2022, 13:19

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

Why won't my RYOBI 18V HP Garden Vacuum & Sweeper locking pin wind?

If you find you can't wind the locking pin of your RYOBI 18V ONE+ Garden Vacuum & Sweeper, you need to first push the locking pin in before starting to wind it clockwise.

Last update: 13/10/2022, 14:02

• Blowers & Garden Vacuums
• Blower Vacs
• Troubleshooting

Why does my RYOBI 18V HP Garden Vacuum & Sweeper have poor suction?

This could be caused by a blockage in the tube. To check and clear this, first remove the battery. Then remove the main tube and check for any small sticks that might be stuck inside by looking through the tube. These are a common cause of leaves…

Last update: 13/10/2022, 14:32

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Cannot tighten Drill Driver Bit in RYOBI Drill Driver chuck

Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.

Last update: 11/09/2024, 16:11