10 Matching results
RYOBI Blower Vacuum won’t start
If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…
Last update: 16/08/2023, 11:52
Why has my RYOBI battery-powered Blower Vacuum lost suction?
If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…
Last update: 01/02/2023, 15:59
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
What to do if your RYOBI 18V HP Garden Vacuum & Sweeper suddenly stops
If your RYOBI 18V HP Garden Vacuum and Sweeper suddenly stops, at the top of the handle there is a red LED - if this blinks, it means the locking pin hasn’t been fully tightened. If this happens, check that the pin is finger-tight until the LED goes…
Last update: 13/10/2022, 13:20
Why does my RYOBI 18V HP Garden Vacuum & Sweeper have poor suction?
This could be caused by a blockage in the tube. To check and clear this, first remove the battery. Then remove the main tube and check for any small sticks that might be stuck inside by looking through the tube. These are a common cause of leaves…
Last update: 13/10/2022, 14:32
RYOBI Edger not making clean defined edge
If your RYOBI Edger isn’t making a clean defined edge, check the condition of your blade and the depth you have set the blade set to. You should also check the locking nut is secured.
Last update: 25/08/2022, 13:55
What to do if RYOBI Edger blade doesn't spin
If your RYOBI Edger blade isn’t spinning while in use, consider raising the height of the blade in order to reduce the strain on the edger. You should also try starting the Edger slightly out of the grass and drop in to position and cut at a steady…
Last update: 20/09/2022, 10:18