How can we help?

• Lawn Mowers
• Push Mowers
• Troubleshooting

What to do if your RYOBI Lawn Mower isn't catching grass

Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…

Last update: 25/11/2022, 15:09

• Lawn Mowers
• Push Mowers
• Maintenance

How to clean a RYOBI Lawn Mower

For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…

Last update: 25/11/2022, 14:58

• Lawn Mowers
• Push Mowers
• Troubleshooting

What to do if your RYOBI Petrol Lawn Mower is running roughly

Stale fuel can cause engines to run poorly, fuel starts to lose its volatility after 30 days. Dirty or old air filters/spark plugs should be replaced for optimal performance. Always try to use fresh fuel in your mower and replace the consumable…

Last update: 16/10/2023, 15:39

• Lawn Mowers
• Push Mowers
• Troubleshooting

What to do if your RYOBI Petrol Lawn Mower runs for a minute then stops

Make sure that you have fresh fuel in the lawn mower (less than 30 days old). Ensure that your air filter is free from any dust and debris - check that the throttle lever is set in the running position.

Last update: 16/10/2023, 17:44

• Lawn Mowers
• Push Mowers
• Maintenance

When to change RYOBI Lawn Mower blades

The need to replace your blade will depend on a variety of factors. As a guide, it is advised to visually inspect the condition of your lawn mower blades in between mowing sessions. If you notice chips in the blade, rust or a blunt cutting edge,…

Last update: 25/11/2022, 14:59

• Power Saws
• Mitre Saws
• Application

How to lock & unlock a RYOBI 18V ONE+ 184mm Mitre Saw's handle

To unlock a 18V ONE+ 184mm Mitre Saw, pull down the handle and hold it there. Head to ryobi.com.au for more information.  The saw handle is locked down with a pin located on the right. Pull the locking pin all the way out.

Last update: 13/09/2024, 16:32

• Power Saws
• Mitre Saws
• Troubleshooting

Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle

If your RYOBI 18V ONE+ 184mm Mitre Saw has a jammed handle, it's possible the saw handle was pulled up or down with it's locking pin not fully in our out and is now obstructing movement. Check that the locking pin is correctly positioned either…

Last update: 13/09/2024, 12:42