8 Matching results
RYOBI Pressure Washer has low or no water pressure
Discover step-by-step solutions for fixing low or no water pressure issues in your RYOBI Pressure Washer.
Last update: 20/10/2023, 08:50
How to set up a RYOBI Pressure Washer
Before you start using your Pressure Washer, you have to prime the line. Ensure the machine is in the off position. Turn on the water supply. Squeeze the trigger until you see a night steady stream of water. Once achieved, the system is primed and…
Last update: 29/08/2023, 12:34
How to set RYOBI Pressure Washer to dispense soap
Depending on the Pressure Washer you own, the soap dispenser will be located in the front or back. If your Pressure Washer has a feed tube, it's important that when you put the cap back on, that the tube is pushed all the way to the bottom of the…
Last update: 29/08/2023, 12:37
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
How to clean a RYOBI Lawn Mower
For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…
Last update: 25/11/2022, 14:58
What to do if your RYOBI Petrol Lawn Mower is running roughly
Stale fuel can cause engines to run poorly, fuel starts to lose its volatility after 30 days. Dirty or old air filters/spark plugs should be replaced for optimal performance. Always try to use fresh fuel in your mower and replace the consumable…
Last update: 16/10/2023, 15:39
What to do if your RYOBI Petrol Lawn Mower runs for a minute then stops
Make sure that you have fresh fuel in the lawn mower (less than 30 days old). Ensure that your air filter is free from any dust and debris - check that the throttle lever is set in the running position.
Last update: 16/10/2023, 17:44