6 Matching results
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26
Why is my RYOBI Drill Driver slow to drill into brick?
To drill into brick, make sure you’re using a RYOBI Drill with a hammer function. Select this mode and use a Masonry Drill Bit. You can improve the drilling speed by selecting a high gear (commonly gear 2 – where possible) - this is usually located…
Last update: 31/01/2023, 13:20
Tools required to install RYOBI LINK to a plasterboard wall
Make sure you have the following tools to install the RYOBI LINK Wall.
Last update: 27/09/2023, 14:25
How to install RYOBI LINK rail to a plasterboard wall
Step-by-step instructions and a how-to video guide on how to install RYOBI LINK Rail/s on a plasterboard or brick wall.
Last update: 27/09/2023, 14:51
How much weight can RYOBI Link hold?
The LINK Rail supports 94kg overall for each rail or 34kg per 280mm. Overall holding weight varies depending on how the rail is fixed to the wall.
Last update: 27/09/2023, 14:53
Can’t tighten screw into anchor when installing RYOBI LINK
This can occur if a Drill Bit larger than 9mm was used & the hole is too big. The maximum Drill Bit & hole size for the RYOBI LINK Wall Anchors is 9mm.
Last update: 27/09/2023, 14:53