8 Matching results
Product Safety Recall Airwave 2-in-1 C1 Brad Nailer/Stapler RA-NBS1832-S
The product that is the subject of the recall is the RYOBI RA-NBS1832-S Airwave 2-in-1 C1 Brad Nailer/Stapler. The Product has been sold through Bunnings retailers throughout Australia from 1 October 2021 – 31 March 2024. Affected products will…
Last update: 20/05/2024, 16:11
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26
How to avoid poor/no suction with a RYOBI Wet & Dry Vacuum
If your RYOBI Wet & Dry Vacuum has poor or no suction, it may be because the filter is dirty and needs to be cleaned. It could also be because the filter is too old to be cleaned, and needs to be replaced. We also recommend you check and empty the…
Last update: 03/02/2023, 11:44
How to swap out your RYOBI Wet & Dry Vacuum filter
To swap out the filter that's used for dry pickup for the one used for wet, simply take it off and grab the foam filter designed for wet pickup and slide it over. Make sure you place it on nice and firm so it protects all the insides. If you use the…
Last update: 19/09/2022, 16:43
How to clean your RYOBI Wet & Dry Vacuum & filter
We recommend straight after you use your machine for wet vacuuming, to clean it and have it setup ready for next time - particularly if the next time is to use the dry feature. The first step is to drain all the water out and then wipe and clean the…
Last update: 26/09/2022, 11:41
How to lock & unlock a RYOBI 18V ONE+ 184mm Mitre Saw's handle
To unlock the handle of a 18V ONE+ 184mm Mitre Saw, pull down the handle and hold it there. The saw handle is locked down with a pin located on the right. Then pull the locking pin all the way out. Slowly bring up the saw handle and then check it…
Last update: 13/09/2023, 10:46
Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle
If your RYOBI 18V ONE+ 184mm Mitre Saw has a jammed handle, it's possible the saw handle was pulled up or down with it's locking pin not fully in our out and is now obstructing movement. Check that the locking pin is correctly positioned either…
Last update: 13/09/2023, 10:42