8 Matching results
Product Safety Recall Airwave 2-in-1 C1 Brad Nailer/Stapler RA-NBS1832-S
The product that is the subject of the recall is the RYOBI RA-NBS1832-S Airwave 2-in-1 C1 Brad Nailer/Stapler. The Product has been sold through Bunnings retailers throughout Australia from 1 October 2021 – 31 March 2024. Affected products will…
Last update: 20/05/2024, 16:11
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26
Why has my RYOBI battery-powered Blower Vacuum lost suction?
If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…
Last update: 01/02/2023, 15:59
What is the metal wire inside my RYOBI battery powered Blower Vacuum?
This is an anti-static grounding device inside the unit and is meant to be there. Don’t attempt to remove or alter it.
Last update: 26/08/2022, 14:16
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
How to lock & unlock a RYOBI 18V ONE+ 184mm Mitre Saw's handle
To unlock the handle of a 18V ONE+ 184mm Mitre Saw, pull down the handle and hold it there. The saw handle is locked down with a pin located on the right. Then pull the locking pin all the way out. Slowly bring up the saw handle and then check it…
Last update: 13/09/2023, 10:46
Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle
If your RYOBI 18V ONE+ 184mm Mitre Saw has a jammed handle, it's possible the saw handle was pulled up or down with it's locking pin not fully in our out and is now obstructing movement. Check that the locking pin is correctly positioned either…
Last update: 13/09/2023, 10:42