How can we help?

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

RYOBI Angle Grinder disc has overtightened and jammed

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc.  To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc: 

Last update: 13/09/2024, 13:20

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Drills & Drivers
• Impact Drivers
• Troubleshooting

Why is my RYOBI 18V ONE+ Impact Driver stuttering/pulsing?

A RYOBI 18V ONE+ Impact Driver that's stuttering or pulsing when drilling in the reverse direction is normal. This tool has an Auto 'A' mode to drive screws when application specific control is required. The 'A' mode rotates in 6 pulses, moving up…

Last update: 15/09/2023, 14:37

• Drills & Drivers
• Impact Drivers
• Application

How to use a RYOBI Impact Driver's 4 pre-set driving modes

The 18V ONE+ HP Brushless 4 Mode Impact Driver has four preset driving modes for light screw driving, medium-duty and heavy-duty applications. The A mode allows you to drive in the forward and reverse direction for specialty screw driving.

Last update: 15/09/2023, 14:36

• Drills & Drivers
• Impact Drivers
• Troubleshooting

Bit slips out of RYOBI Impact Driver when driving screws

The chuck will accept the bit by clicking it into the chuck. The bit should not be able to be removed by just pulling on the end of it, you will need to lift the sleeve around the chuck to release the bit.

Last update: 11/09/2024, 16:04