12 Matching results
How to fit & remove Angle Grinder disc using a pin spanner
If your RYOBI Angle Grinder has a pin spanner locking nut, you'll need a pin spanner to fit and remove the disc. Don’t attempt to remove the disc without one, as it may damage the spindle.
Last update: 29/08/2023, 13:19
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
RYOBI Multi Tool sparking when turned on
Sparking can occur on new, brushed motor tools due to the brushes within the motor not being worn in. This is not an issue and over time, this will stop occurring - it's caused by friction against the carbon brushes. However, if there are…
Last update: 19/04/2023, 16:27
Can I use RYOBI Multi Tool to remove silicone?
A RYOBI Multi Tool can be used to remove silicone sealant with a compatible blade. We recommend the POWERFIT 52mm 2PC Scraper Blade, which you can purchase separately.
Last update: 19/04/2023, 16:30
How to install or change RYOBI Multi Tool blade
To change blades, release the latch by pulling it upwards until the blade holder opens. Ensure the lever is fully released before removing or inserting a new blade. Once the new blade is inserted, pull down the lever until the blade holder snaps…
Last update: 18/09/2023, 09:59