7 Matching results
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01
RYOBI Hedge Trimmer blades not cutting or getting jammed
If your RYOBI Hedge Trimmer Blade isn’t cutting or is getting jammed, your blades may need maintenance. Lubrication is required to keep the friction between the blades low to prevent excess heat.
Last update: 13/07/2023, 16:20
What to do if your RYOBI Hedge Trimmer blades are sticking
If your Hedge Trimmer blades are sticking, clean the blades with a dry brush or cloth. You should also ensure blades are lubricated before and after every use, as this helps to clean off sticky material, like sap.
Last update: 20/09/2022, 15:57
What to do if your RYOBI Hedge Trimmer cuts out
If your RYOBI Hedge Trimmer cuts out, the material being cut may be too thick. Check your Hedge Trimmer’s maximum cut capacity.
Last update: 20/09/2022, 15:58
How to clean RYOBI Hedge Trimmer cutting bar
To clean the cutting bar of your Hedge Trimmer, clean the blades with a dry brush or cloth. Lubricating the blades will also help to clean off sticky material, like sap. Lubricate the blades with a plant-friendly lubricant. Then run the unit to help…
Last update: 15/09/2022, 10:44
What's the maximum cutting capacity of my RYOBI Hedge Trimmer?
Each RYOBI Hedge Trimmers has a maximum cut capacity. Check the serial plate for your model number and refer to the following list.
Last update: 15/09/2022, 10:37