10 Matching results
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01
RYOBI Multi Tool sparking when turned on
Sparking can occur on new, brushed motor tools due to the brushes within the motor not being worn in. This is not an issue and over time, this will stop occurring - it's caused by friction against the carbon brushes. However, if there are…
Last update: 19/04/2023, 16:27
Can I use RYOBI Multi Tool to remove silicone?
A RYOBI Multi Tool can be used to remove silicone sealant with a compatible blade. We recommend the POWERFIT 52mm 2PC Scraper Blade, which you can purchase separately.
Last update: 19/04/2023, 16:30
How to install or change RYOBI Multi Tool blade
To change blades, release the latch by pulling it upwards until the blade holder opens. Ensure the lever is fully released before removing or inserting a new blade. Once the new blade is inserted, pull down the lever until the blade holder snaps…
Last update: 18/09/2023, 09:59
RYOBI Multi Tool quick change not working
Remove the battery to ensure no power is provided to the tool. Check for any physical damage to the lever. Clean any debris or material from the lever using a brush as this might be preventing the lever from functioning. Ensure the accessory is…
Last update: 19/04/2023, 16:33
RYOBI Multi Tool doesn’t have enough power
Multi-Functional Tool power
Last update: 18/07/2022, 16:23