How can we help?

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Bit slips out of RYOBI Drill Driver when driving screws

Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…

Last update: 22/08/2022, 17:09

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck

The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…

Last update: 03/02/2023, 16:01

• Drills & Drivers
• Drill Drivers
• Troubleshooting

Cannot tighten Drill Driver Bit in RYOBI Drill Driver chuck

Check that the chuck securing screw has potentially loosened – tighten clockwise with a matching bit (PH3 or Torx T30 usually) This occurs when Bits are dropped all the way into the bottom of the chuck.

Last update: 11/09/2024, 16:11

• Drills & Drivers
• Drill Drivers
• Getting Started

What are the settings for on my Ryobi Drill Driver?

The settings are to help with drilling holes & driving screws properly into the desired material.

Last update: 11/09/2024, 17:42

• Drills & Drivers
• Drill Drivers
• Maintenance

How to replace the Drill Chuck

ALWAYS disconnect the tool from power before starting. You will need a PH3 Screwdriver, a 10-13mm Allen key & a Rubber Mallet. To start, locate the internal screw within the centre of the Drill chuck.

Last update: 11/09/2024, 17:52

• Drills & Drivers
• Drills
• Troubleshooting

RYOBI Drill has no power or is losing power

Check the battery charge level – it is normal that a battery will lose some minor power output as the charge level drops. If the charge level is too low, the tool may stop under load. In this case you may need to charge your battery or change…

Last update: 11/09/2024, 12:17

• Drills & Drivers
• Drill Drivers
• Troubleshooting

RYOBI Cordless Drill Driver cutting out

Check that the Drill may is set on the correct drill or driving settings, the speed may be too high/ low, in reverse instead of forward, or the Adjustable clutch may not be set to the Drill mode (when drilling.) Generally, Slower the speed, the more…

Last update: 11/09/2024, 13:34