8 Matching results
How to fit & remove Angle Grinder disc using a pin spanner
If your RYOBI Angle Grinder has a pin spanner locking nut, you'll need a pin spanner to fit and remove the disc. Don’t attempt to remove the disc without one, as it may damage the spindle.
Last update: 29/08/2023, 13:19
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
Why is my RYOBI Drill Driver slow to drill into brick?
To drill into brick, make sure you’re using a RYOBI Drill with a hammer function. Select this mode and use a Masonry Drill Bit. You can improve the drilling speed by selecting a high gear (commonly gear 2 – where possible) - this is usually located…
Last update: 31/01/2023, 13:20
How to lock & unlock a RYOBI 18V ONE+ 184mm Mitre Saw's handle
To unlock the handle of a 18V ONE+ 184mm Mitre Saw, pull down the handle and hold it there. The saw handle is locked down with a pin located on the right. Then pull the locking pin all the way out. Slowly bring up the saw handle and then check it…
Last update: 13/09/2023, 10:46
Fix a RYOBI 18V ONE+ 184mm Mitre Saw's jammed handle
If your RYOBI 18V ONE+ 184mm Mitre Saw has a jammed handle, it's possible the saw handle was pulled up or down with it's locking pin not fully in our out and is now obstructing movement. Check that the locking pin is correctly positioned either…
Last update: 13/09/2023, 10:42