9 Matching results
How to fit & remove Angle Grinder disc using a pin spanner
These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner
Last update: 13/09/2024, 12:21
RYOBI Angle Grinder disc has overtightened and jammed
Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc. To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc:
Last update: 13/09/2024, 13:20
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 13/09/2024, 13:29
What size disc is suitable for a RYOBI Angle Grinder?
The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…
Last update: 13/09/2024, 13:59
RYOBI Hedge Trimmer blades not cutting or getting jammed
If your RYOBI Hedge Trimmer Blade isn’t cutting or is getting jammed, your blades may need maintenance. Lubrication is required to keep the friction between the blades low to prevent excess heat.
Last update: 13/07/2023, 16:20
What to do if your RYOBI Hedge Trimmer blades are sticking
If your Hedge Trimmer blades are sticking, clean the blades with a dry brush or cloth. You should also ensure blades are lubricated before and after every use, as this helps to clean off sticky material, like sap.
Last update: 20/09/2022, 15:57
What to do if your RYOBI Hedge Trimmer cuts out
If your RYOBI Hedge Trimmer cuts out, the material being cut may be too thick. Check your Hedge Trimmer’s maximum cut capacity.
Last update: 20/09/2022, 15:58