9 Matching results
Can I use a larger disc size with my RYOBI Angle Grinder?
Don’t use a disc larger than the maximum cutting capacity outlined below and in the product user manual, as a larger disc can cause damage to the tool, and potentially harm you or a bystander.
Last update: 13/09/2024, 11:06
How to fit & remove Angle Grinder disc using a pin spanner
These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner
Last update: 13/09/2024, 12:21
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 13/09/2024, 13:29
What size disc is suitable for a RYOBI Angle Grinder?
The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…
Last update: 13/09/2024, 13:59
RYOBI Edger not making clean defined edge
If your RYOBI Edger isn’t making a clean defined edge, check the condition of your blade and the depth you have set the blade set to. You should also check the locking nut is secured.
Last update: 25/08/2022, 13:55
What to do if RYOBI Edger blade doesn't spin
If your RYOBI Edger blade isn’t spinning while in use, consider raising the height of the blade in order to reduce the strain on the edger. You should also try starting the Edger slightly out of the grass and drop in to position and cut at a steady…
Last update: 20/09/2022, 10:18
What to do if RYOBI Edger won't start
If your RYOBI Edger isn’t starting, for battery models, check the battery has charge by pressing the fuel gauge. For AC models, turn the power point switch off and check the cord is inserted correctly. You should also check the coupler connection…
Last update: 20/09/2022, 10:20