How can we help?

• Grinders
• Angle Grinders
• Application

Can I use a larger disc size with my RYOBI Angle Grinder?

Don’t use a disc larger than the maximum cutting capacity outlined below and in the product user manual, as a larger disc can cause damage to the tool, and potentially harm you or a bystander.

Last update: 13/09/2024, 11:06

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Caulking Guns
• Caulking Guns
• Troubleshooting

Silicon is running out of RYOBI Caulking Gun tube & fouling

This can happen if the hole that the silicone is being forced out of is too small and the gun’s setting is too high. Generally, the rule of thumb is that the smaller the hole, the lower the setting needs to be on the gun.

Last update: 10/07/2023, 17:16

• Caulking Guns
• Caulking Guns
• Getting Started

What size battery is compatible with the Ryobi One+ Caulking Gun?

Any battery from the RYOBI ONE+ range is suitable. Just note that higher capacity batteries will provide a longer run time but will also be heavier. As a guide a 2Ah Battery will provide enough run time for approximately 2,000 cartridges. However,…

Last update: 20/10/2022, 16:14

• Caulking Guns
• Caulking Guns
• Getting Started

How to fit a cartridge into a Ryobi ONE+ Caulking Gun

The Caulk or Adhesive will need the top taken off with either a caulking tool or a utility knife. When cutting the top always place the tube on a solid surface and cut away from your body - typically the cartridge will have a line on the tip where…

Last update: 20/10/2022, 16:15