18V ONE+ HP™ Garden Vacuum & Sweeper 6.0AH Kit (R18XBLV26)

To detach the motor from the handle, first loosen the safety pin about three quarters of the way. Then slide and hold this button to the unlock position as you twist the motor apart from the front handle. To refit the motor, line up the locating…

First slide the guide wheels on to the lower blower tube. Once on, pulling up this tab allows you to adjust the position of the wheels to best support the bottom of the tool. Then attach this section to the lower vacuum tube by sliding it into…

To attach the collection bag to a RYOBI 18V HP Garden Vacuum & Sweeper, start by pulling its collar over the elbow tube. Locate the slot in the front of the collar with the tab at the front of the elbow. - Now, pull the bag handle up until it…

A RYOBI 18V HP Garden Vacuum & Sweeper motor has three speed settings controlled by pressing the up or down buttons. Pressing and holding the power button again for 2 seconds will turn off the motor.

To access the fan blade, you need to remove the motor from the main handle. To do this, first loosen the safety pin about three quarters of the way. Then slide and hold the button to the unlock position as you twist the motor apart from the front…

To clean the collection bag of a RYOBI 18V HP Garden Vacuum & Sweeper, turn the bag inside-out and remove the plastic sleeve. With your garden hose, give it a light spray.
Hang it out to dry before using it again. 

Holding the power head angled slightly down at the back, align the square openings of the lower blower tubes and push them partially together. Now, line up the opening of the power head with the vacuum tube. Then, as you push them together, make…

Our zipless bag design makes this job easy. Simply unhook the bag and then slide off the plastic sleeve and empty the contents. You should empty your collection bag when it's full and after every use.

To clean the collection bag of a RYOBI 18V HP Garden Vacuum & Sweeper, with the bag turned inside-out and the plastic sleeve removed, give it a light spray with your garden hose and hang it out to fully dry before using it again.

To turn a RYOBI 18V HP Garden Vacuum & Sweeper on, press and hold the power button located on the top of the handle for two seconds. To turn off, press and hold the same power button for two seconds.

To switch between blowing and vacuuming, locate the mode level on the side of the tool. In the down position the tool is in blower mode which utilises the small tube on the underside. If you notice the airflow in either mode is poor, check that this…

If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.

If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged.…

This is an anti-static grounding device inside the unit and is meant to be there. Don’t attempt to remove or alter it.

If your RYOBI 18V HP Garden Vacuum & Sweeper won't start, check the battery has charge by pressing the fuel gauge button at the front of it - it needs to have two or more LEDs on. At the top of the handle there is a red LED. If this blinks…

This could be caused by a blockage in the tube. To check and clear this, first remove the battery. Then remove the main tube and check for any small sticks that might be stuck inside by looking through the tube. These are a common cause of leaves…