8 Matching results
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
How to clean a RYOBI Lawn Mower
For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…
Last update: 25/11/2022, 14:58
What to do if your RYOBI Petrol Lawn Mower is running roughly
Stale fuel can cause engines to run poorly, fuel starts to lose its volatility after 30 days. Dirty or old air filters/spark plugs should be replaced for optimal performance. Always try to use fresh fuel in your mower and replace the consumable…
Last update: 16/10/2023, 15:39
What to do if your RYOBI Petrol Lawn Mower runs for a minute then stops
Make sure that you have fresh fuel in the lawn mower (less than 30 days old). Ensure that your air filter is free from any dust and debris - check that the throttle lever is set in the running position.
Last update: 16/10/2023, 17:44
When to change RYOBI Lawn Mower blades
The need to replace your blade will depend on a variety of factors. As a guide, it is advised to visually inspect the condition of your lawn mower blades in between mowing sessions. If you notice chips in the blade, rust or a blunt cutting edge,…
Last update: 25/11/2022, 14:59
How to lock & unlock a RYOBI Dual Bevel Sliding Mitre Saw's handle
The saw handle is locked down with a pin located on the right. 3To unlock the saw, pull down the handle and hold it there. Pull the locking pin all the way out.
Last update: 13/09/2024, 09:52
RYOBI Dual Bevel Sliding Mitre Saw handle is jammed
Its possible the saw handle was pulled down or up with its locking pin not fully in or out and is now obstructing the movement. Check the pin is correctly positioned.
Last update: 13/09/2024, 09:45