7 Matching results
RYOBI Brad Nailer Brads aren’t flush
The driving depth of the fastener may need to be adjusted. Test the depth on a scrap workpiece to determine the required depth for the application. To determine depth of drive, adjust the air pressure on the tool by rotating the dial on the back of…
Last update: 16/03/2023, 11:20
RYOBI Brad Nailer jamming
It's likely a jammed fastener - disconnect the air hose to remove the jammed fastener. Additionally, always ensure the correct gauge of nails is being used, and check the nails are straight and in condition.
Last update: 08/08/2022, 16:38
RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough
If your RYOBI Airwave/Pneumatic Brad Nailer doesn't fire deep enough and the fastener is protruding, increase the air pressure by increments of 0.5 bar, checking the result after each new adjustment. It is preferred to adjust the depth adjustment…
Last update: 16/03/2023, 14:26
Why doesn't my RYOBI Pole Pruner battery last?
Check your battery’s charge level indicator. Batteries will lose power as the charge reduces. If your battery is nearly depleted you will experience lower power than a fully charged battery. The larger the battery, the longer the chainsaw will run…
Last update: 20/09/2022, 14:49
Why is my 18V/36V RYOBI Pole Pruner not starting?
If your 18V or 36V RYOBI Pole Pruner isn't starting, it may be your battery - check your battery’s charge level indicator to ensure it's fully charged, check the battery is seated correctly and make sure the battery isn't too hot. Also, make sure…
Last update: 20/09/2022, 14:50
Why is my 18V/36V RYOBI Pole Pruner charger is not working?
If your 18V or 36V RYOBI Pole Pruner charger isn't working, make sure your battery is correctly inserted in charger, and that the battery isn’t hot. RYOBI batteries have overheat protection built into them. If the battery is too hot the charger will…
Last update: 20/09/2022, 14:52
Why does my 18V/36V RYOBI Pole Pruner leak oil when not in use?
Oil leaking is a common occurrence and does not signify an issue with your Pruner. Oil is pumped through grooves around the chain bar to ensure the chain and bar are lubricated correctly. Therefore it’s common and expected to have oil left in these…
Last update: 20/09/2022, 14:53