8 Matching results
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
RYOBI Blower Vacuum won’t start
If your RYOBI battery powered Blower Vacuum won’t start, first check if the battery is low. Check the battery has at least 1 solid bar on it’s fuel gauge. If there is a flashing single bar, it's indicating the battery is fully discharged. Recharge…
Last update: 16/08/2023, 11:52
Why has my RYOBI battery-powered Blower Vacuum lost suction?
If your RYOBI Battery powered Blower Vacuum has lost suction and isn’t vacuuming well, make sure the bag is empty and clean, as this can impact the performance of the unit. Also check for debris in the tubes, around the propeller or in the elbow as…
Last update: 01/02/2023, 15:59
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
What to do if your RYOBI 18V HP Garden Vacuum & Sweeper won't start
If your RYOBI 18V HP Garden Vacuum & Sweeper won't start, check the battery has charge by pressing the fuel gauge button at the front of it - it needs to have two or more LEDs on. At the top of the handle there is a red LED. If this blinks, it means…
Last update: 13/10/2022, 13:19
Why won't my RYOBI 18V HP Garden Vacuum & Sweeper locking pin wind?
If you find you can't wind the locking pin of your RYOBI 18V ONE+ Garden Vacuum & Sweeper, you need to first push the locking pin in before starting to wind it clockwise.
Last update: 13/10/2022, 14:02