8 Matching results
Why does my RYOBI Angle Grinder keep cutting out?
Angle Grinders are commonly equipped with several user safety and tool protection systems, such as overload, over-temperature, and anti- kickback. Consider the following that could be causing the issue: Excess Force, Angle of Application, or a below…
Last update: 11/08/2023, 15:21
RYOBI Angle Grinder disc has overtightened and jammed
An overtightened or jammed disc is usually caused by the disc not being installed correctly, causing it to overtighten. To fix this issue and prevent this from happening again, you’ll need to remove and refit the disc.
Last update: 29/08/2023, 13:25
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
RYOBI Edger not making clean defined edge
If your RYOBI Edger isn’t making a clean defined edge, check the condition of your blade and the depth you have set the blade set to. You should also check the locking nut is secured.
Last update: 25/08/2022, 13:55
What to do if RYOBI Edger blade doesn't spin
If your RYOBI Edger blade isn’t spinning while in use, consider raising the height of the blade in order to reduce the strain on the edger. You should also try starting the Edger slightly out of the grass and drop in to position and cut at a steady…
Last update: 20/09/2022, 10:18
What to do if RYOBI Edger won't start
If your RYOBI Edger isn’t starting, for battery models, check the battery has charge by pressing the fuel gauge. For AC models, turn the power point switch off and check the cord is inserted correctly. You should also check the coupler connection…
Last update: 20/09/2022, 10:20
What to do if your RYOBI Edger isn't cutting properly
If your RYOBI Edger isn’t cutting properly, check the condition of your blade and raise the height of the blade to reduce the strain on the edger. For 18V or 36V battery, check the battery has charge by pressing the fuel gauge. For AC, turn off the…
Last update: 20/09/2022, 10:21