14 Matching results
Can you put a steel/wire brush on a RYOBI Bench Grinder?
Yes, you can put a steel/wire brush on your Bench Grinder. Make sure its diameter matches that of our recommended and existing Disc & Bore size, and that the RPM capability of the new Steel/Wire Brush is also rated to handle the RPM of the Ryobi…
Last update: 13/04/2023, 14:35
Is the RYOBI Bench Grinder compatible with sanding accessories?
The Bench Grinder is compatible with sanding accessories. However, ensure the chosen accessory is compatible with bench grinder use, and can achieve and/or deliver the intended result. Consider factors such as RPM compatibility and the different…
Last update: 13/04/2023, 14:37
RYOBI Drill has no power or is losing power
Check if the battery is charged - if so, try another battery to confirm whether it is the tool or battery that isn’t working. Inspect your Drill for dust build up - if there, we recommend removing debris from your Drill with a clean paint brush,…
Last update: 19/08/2022, 15:49
Drill Bits slip in RYOBI Drill Driver chuck
Depending on the type of chuck, it’s common for smaller Drill Bits (around 1-3mm or less) not to grip. The Drill Bit may also have dust or liquid on the Bit, which might cause it to slip - this can be prevented by cleaning the end of the Drill Bit…
Last update: 24/08/2023, 14:24
RYOBI Drill Driver chuck hard to adjust
If your RYOBI Drill Driver chuck is hard to adjust, the chuck might have debris in the jaws, which could make adjusting the chuck stiff. Open the chuck fully and clean out any build-up of dirt and dust - preferably with compressed air.
Last update: 09/08/2022, 14:39
Bit slips out of RYOBI Drill Driver when driving screws
Bits can slip if the tips are very worn or are poor quality. Try inspecting the tip of the Bit to ensure it is not excessively worn. You should also make sure you're using the correct Bit for the fastener. Refer to the fastener packaging for correct…
Last update: 22/08/2022, 17:09
Can't tighten Drill Driver Bit in RYOBI Drill Driver chuck
The chuck securing screw has potentially loosened - tighten to avoid dropping Bits all the way into the bottom of the chuck. Depending on the type of chuck, make sure when tightening that the Bit is seated on the chuck jaws with equal seating /…
Last update: 03/02/2023, 16:01