9 Matching results
How to fit & remove Angle Grinder disc using a pin spanner
These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner
Last update: 13/09/2024, 12:21
RYOBI Angle Grinder disc has overtightened and jammed
Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc. To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc:
Last update: 13/09/2024, 13:20
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 13/09/2024, 13:29
What size disc is suitable for a RYOBI Angle Grinder?
The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…
Last update: 13/09/2024, 13:59
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
How to clean a RYOBI Lawn Mower
For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…
Last update: 25/11/2022, 14:58
What to do if your RYOBI Petrol Lawn Mower is running roughly
Stale fuel can cause engines to run poorly, fuel starts to lose its volatility after 30 days. Dirty or old air filters/spark plugs should be replaced for optimal performance. Always try to use fresh fuel in your mower and replace the consumable…
Last update: 16/10/2023, 15:39