8 Matching results
How to fit & remove Angle Grinder disc using a pin spanner
These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner
Last update: 13/09/2024, 12:21
RYOBI Angle Grinder disc has overtightened and jammed
Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc. To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc:
Last update: 13/09/2024, 13:20
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 13/09/2024, 13:29
What size disc is suitable for a RYOBI Angle Grinder?
The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…
Last update: 13/09/2024, 13:59
RYOBI Multi Tool sparking when turned on
Sparking can occur on new, brushed motor tools due to the brushes within the motor not being worn in. This is not an issue and over time, this will stop occurring - it's caused by friction against the carbon brushes. However, if there are…
Last update: 19/04/2023, 16:27
Can I use RYOBI Multi Tool to remove silicone?
A RYOBI Multi Tool can be used to remove silicone sealant with a compatible blade. We recommend the POWERFIT 52mm 2PC Scraper Blade, which you can purchase separately.
Last update: 19/04/2023, 16:30
RYOBI Multi Tool quick change not working
Remove the battery to ensure no power is provided to the tool. Check for any physical damage to the lever. Clean any debris or material from the lever using a brush as this might be preventing the lever from functioning. Ensure the accessory is…
Last update: 19/04/2023, 16:33