How can we help?

• Grinders
• Angle Grinders
• Application

How to fit & remove Angle Grinder disc using a pin spanner

These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner

Last update: 13/09/2024, 12:21

• Grinders
• Angle Grinders
• Troubleshooting

RYOBI Angle Grinder disc has overtightened and jammed

Not installing the disc correctly can cause the disc to overtighten, and potentially jam the disc.  To avoid this from happening, or to fix this issue and prevent this from happening again, you’ll need to remove and refit the disc: 

Last update: 13/09/2024, 13:20

• Grinders
• Angle Grinders
• Troubleshooting

Can’t remove cutting disc from Angle Grinder

Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…

Last update: 13/09/2024, 13:29

• Grinders
• Angle Grinders
• Application

What size disc is suitable for a RYOBI Angle Grinder?

The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity.  Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…

Last update: 13/09/2024, 13:59

• Biscuit Joiners
• Biscuit Joiners
• Troubleshooting

RYOBI Biscuit Joiner not cutting well

If your Biscuit Joiner isn't cutting to the desired results, check your blade for any obvious signs of damage or wear and tear (such as broken blade teeth), which can lead to a poor cut and may need replacing.

Last update: 22/08/2022, 17:07

• Pressure Washers
• Pressure Washers
• Application

RYOBI Pressure Washer has low or no water pressure

Discover step-by-step solutions for fixing low or no water pressure issues in your RYOBI Pressure Washer.

Last update: 20/10/2023, 08:50

• Pressure Washers
• Pressure Washers
• Application

How to set up a RYOBI Pressure Washer

Before you start using your Pressure Washer, you have to prime the line. Ensure the machine is in the off position. Turn on the water supply. Squeeze the trigger until you see a night steady stream of water. Once achieved, the system is primed and…

Last update: 29/08/2023, 12:34