16 Matching results
Can I use a larger disc size with my RYOBI Angle Grinder?
Don’t use a disc larger than the maximum cutting capacity outlined below and in the product user manual, as a larger disc can cause damage to the tool, and potentially harm you or a bystander.
Last update: 13/09/2024, 11:06
How to fit & remove Angle Grinder disc using a pin spanner
These instructions apply to RYOBI Angle Grinders with a pin spanner locking nut. The locking nut has four holes around the centre thread to position the pin spanner
Last update: 13/09/2024, 12:21
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 13/09/2024, 13:29
What size disc is suitable for a RYOBI Angle Grinder?
The compatible disc size is dependent on your RYOBI Angle Grinder's maximum disc capacity. Don’t use a disc larger than the maximum cutting capacity outlined below, as a larger disc can cause damage to the tool, and potentially harm you or a…
Last update: 13/09/2024, 13:59
How to operate a RYOBI 36V Lawn Mower's self-propelled mode
The motor is controlled by the thumb paddle, which when pushed drives the mower forward. Speed is then controlled by the slider switch, which allows you to set your desired pace. We recommend starting off slow until you get used to it.
Last update: 11/07/2023, 10:00
How to reset a 36V RYOBI Lawn Mower's Blade Check warning light
To reset a 36V RYOBI Lawn Mower's blade check warning light, hold down the battery icon on the dashboard for 3 seconds.
Last update: 17/11/2022, 15:09
Understanding the RYOBI 36V Lawn Mower modes
A dashboard is located at the top of the Mower's handle. It provides a single point to set the three moving modes, and pressing the mode button cycles through each of the modes. ECO mode locks the blade in low speed to provide the best runtime, but…
Last update: 29/08/2023, 14:21