![TTI Brands Home](/themes/custom/tti/images//icons/logo.png)
14 Matching results
Can’t remove cutting disc from Angle Grinder
Typically, a cutting disc can be hard to remove because the locking nut was overtightened when fitted to the grinder. A disc will tighten under loading, so excessive tightening will cause issues with removal, that may require a pin spanner or wrench…
Last update: 01/08/2023, 11:27
How to fit a guard to a RYOBI Angle Grinder
It is important that the grinder is always used with a guard fitted, and (if included in your model) the additional clip-on guard if you are cutting. To fit the guard, place the guard on the grinder housing with the grooves aligned (arrow…
Last update: 11/08/2023, 15:29
What size disc is suitable for a RYOBI Angle Grinder?
For a RYOBI 125mm Angle Grinder, the maximum disc capacity is 125mm/5 inches, so you need a 125mm disc. For a RYOBI 115mm Angle Grinder, the maximum disc capacity is 115m, so you need a 115mm disc. Don’t use a disc larger than the maximum cutting…
Last update: 02/08/2023, 10:07
RYOBI Petrol Blower Vacuum difficult to start
If you’re having trouble starting your RYOBI Petrol Blower Vacuum, first make sure you’re following the correct starting process. Also check for a flooded engine, stale fuel, dirty air filter/spark plug or incorrect fuel mixture. You may have also…
Last update: 26/08/2022, 10:31
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
What to do if RYOBI Petrol Blower runs poorly
If your RYOBI Petrol Blower is running poorly, first make sure you’re following the correct starting process. Also check for a flooded engine, stale fuel, dirty air filter/spark plug or incorrect fuel mixture. You may have also left the choke hold…
Last update: 29/08/2022, 09:33
Why is my RYOBI Drill Driver slow to drill into brick?
To drill into brick, make sure you’re using a RYOBI Drill with a hammer function. Select this mode and use a Masonry Drill Bit. You can improve the drilling speed by selecting a high gear (commonly gear 2 – where possible) - this is usually located…
Last update: 31/01/2023, 13:20