18V ONE+ 25mm Pruning Secateurs Tool Only (R18SEC)

After each use, remove the battery pack before cleaning or maintenance. Wipe the secateurs with a soft, dry cloth, avoiding water or solvents that could damage the electronics and housing. Lubricate the blade with light oil through the bolt hole,…

To operate the Secateurs, insert a compatible battery pack until it clicks securely (2Ah recommended for lightweight use). Power on the tool by squeezing and holding the trigger for 4 seconds until the cutting blade opens. To cut, release the…

To replace or sharpen the cutting blade, first remove the battery pack to ensure safety. Use a T10 screwdriver to remove the housing screws, then remove the locking screw and nut with a hex key and socket wrench to take out the blade. Install the…

Learn the process of replacing your RYOBI Secateurs blades with our step-by-step guide.

Discover step by step instructions for maintaining your RYOBI Secateurs.

Explore the reasons behind your RYOBI secateurs struggling with timber and find practical solutions in our troubleshooting guide.

Discover the common reasons behind your RYOBI secateurs not starting and learn expert solutions to get them back in action.

If the secateurs are inactive for 30 seconds, they will automatically enter sleep mode, indicated by the LED turning off and a single beep. To wake the tool, squeeze and hold the trigger for 4 seconds until the blades open and the LED lights up.…

The R18SEC Secateurs are designed to cut green branches up to 25 mm in diameter and dry branches up to 20 mm. Cutting branches larger than these limits may damage the tool or cause personal injury, so always stay within the recommended range for…

To operate the secateurs safely, always wear appropriate protective equipment such as eye and head protection and heavy-duty gloves. Keep your hands and body clear of the blades while the tool is powered, avoid using the tool in wet conditions, and…

Cutting very dry or hard wood can activate the secateurs’ over-temperature protection, indicated by the LED flashing three times and three beeps. Stop using the tool immediately and allow it to cool for 10–15 minutes before resuming. Always stay…

A flashing LED with continuous beeping indicates the blades are jammed. The secateurs will automatically open the blades to prevent damage. Wait until the LED stops flashing and the beeping ceases, then clear any debris or blockage from the blades.…