1400w 1450psi Pressure Washer (RACPWS1)

Yes, you can connect your pressure washer to a rainwater tank, provided the tank supplies clean water at adequate pressure. It’s important to install a filter to prevent debris from entering and damaging the pump. If the water pressure is too low,…

Yes, you can use an extension hose with your pressure washer, but make sure it’s rated for high pressure and keep the total length under 15 meters, as longer hoses can reduce water pressure and overall performance.

No, Ryobi pressure washers are designed for cold water use only. Using hot water can damage the seals and internal components. Always refer to your model’s manual to confirm the recommended temperature limits before use.

Yes, you can use your pressure washer to clean a car, but make sure to use a low-pressure nozzle and keep the spray at least 30 cm away from the surface. Avoid directing water at seals, tires, or electrical components, and use a car-safe detergent…

To improve low water pressure, check the garden hose for any kinks or restrictions, clean the inlet filter, and inspect the nozzle for blockages. If you’re using tank water, make sure the water quality is clean and the supply pressure is adequate.…

To prime your pressure washer before use, turn on the water supply while keeping the machine switched off, then squeeze and hold the trigger until water flows steadily for 1–2 minutes. This process removes trapped air from the pump and helps ensure…

To store your pressure washer during winter, drain all water from the pump and hoses to prevent freezing damage, then keep the unit in a dry, frost-free area. For added protection, run a pump saver solution through the system before storing it to…

To unclog your nozzle, remove it from the wand and insert a nozzle-cleaning pin or straightened paper clip to gently push out any debris inside. Rinse the nozzle thoroughly with water to clear any remaining particles, then reinstall it onto the wand.

If your pressure washer isn’t providing enough power, start by confirming the water supply, as low pressure is often caused by weak water flow. Fully open the outdoor faucet, disconnect the garden hose from the washer, and let water run for about 30…

If your pressure washer won’t start, first unplug it and test the power outlet with another device to make sure it’s working. If you’re using an extension cord, confirm it’s heavy-duty, less than 20 meters long, and not damaged. If the outlet and…

If your RYOBI Pressure Washer starts then stops straight away, check that the tap is turned on fully, and that there’s enough water pressure coming from the water source. Drawing water from sources like a bucket will not provide enough pressure for…

If using for an extended period, it's possible the motor over-heated and the thermal overload switch has activated. Allow time for the motor to cool and then restart. The motor maybe low on power if running extra-long or multiple extension…

If your RYOBI Pressure Washer won’t dispense soap, ensure that your lance is set to low pressure. To do so, twist the end of the lance and open it to its widest setting to allow a greater water flow at a decreased pressure. Then allow up to 45…

If you can’t disconnect the pressure hose from your RYOBI Pressure Washer, it may be because the pressure hose is still under water pressure, which needs to be released. Turn off the water supply, then turn off the machine. Now, squeeze the trigger…

Use only detergents that are specifically approved for pressure washers. Avoid household cleaners such as bleach or ammonia, as they can damage seals and internal components. Always dilute the detergent according to the manufacturer’s instructions…