7 Matching results
RYOBI Petrol Blower Vacuum difficult to start
If you’re having trouble starting your RYOBI Petrol Blower Vacuum, first make sure you’re following the correct starting process. Also check for a flooded engine, stale fuel, dirty air filter/spark plug or incorrect fuel mixture. You may have also…
Last update: 26/08/2022, 10:31
RYOBI Blower Vacuum can’t switch between modes
If your RYOBI Blower Vacuum can’t switch between modes, it may be because of a build-up of debris in the lever or deep inside the elbow.
Last update: 26/08/2022, 14:33
What to do if RYOBI Petrol Blower runs poorly
If your RYOBI Petrol Blower is running poorly, first make sure you’re following the correct starting process. Also check for a flooded engine, stale fuel, dirty air filter/spark plug or incorrect fuel mixture. You may have also left the choke hold…
Last update: 29/08/2022, 09:33
What to do if your RYOBI Lawn Mower isn't catching grass
Firstly, check for blockages. Blockages usually occur in the chute between the mower deck & catcher, which block airflow and prevent grass from being thrown to the back of the catcher. Mowing in wet or unruly conditions are often the cause of this…
Last update: 25/11/2022, 15:09
How to clean a RYOBI Lawn Mower
For a battery-powered or electric mower, remove the battery and/or red safety key from the lawn mower. Tilt the lawn mower on its side and clean the deck with a brush or cloth. DO NO USE WATER on these products. For a petrol-powered lawn mower, wash…
Last update: 25/11/2022, 14:58
When to change RYOBI Lawn Mower blades
The need to replace your blade will depend on a variety of factors. As a guide, it is advised to visually inspect the condition of your lawn mower blades in between mowing sessions. If you notice chips in the blade, rust or a blunt cutting edge,…
Last update: 25/11/2022, 14:59
Why is my RYOBI Drill Driver slow to drill into brick?
To drill into brick, make sure you’re using a RYOBI Drill with a hammer function. Select this mode and use a Masonry Drill Bit. You can improve the drilling speed by selecting a high gear (commonly gear 2 – where possible) - this is usually located…
Last update: 31/01/2023, 13:20